How To Perform A Factory Reset (E Series)

 

How To Perform A Factory Reset.

 

Step 1: Please make sure your camera is connect to a power supply. 

Step 2: Once power is applied to the camera, to reset the camera, press and hold the reset button on the bottom lower portion of the camera for 8 seconds

IMG_6120.jpg

Step 3: Once the LED indicator light on the front of the device turns red, please release the reset button. From this point the camera will being to reset and reboot. 

IMG_6122.jpg

Step 4: Once the camera has completed its factory reset process, the camera will then automatically detect your WiFi network and a the LED light will change from red to a solid green. This indicates that the device has completed its reset process and is currently connected to your WiFi network. 

IMG_6123.jpg

For more supplemental information regarding indicator lights on your camera and their meanings, please refer to the reference table below:

Reference Table 2‑2 below for additional details regarding the indicator light.

Indicator light status

Device status

Solid Red

Device may be malfunctioning. Can also signal a reboot if the light stays red for a few seconds but then turns green.

Green, Flashing Slowly

Boot complete, ready to connect to Wi-Fi

Green, Flashing Rapidly

Attempting to connect to Wi-Fi

Green, Solid

Wi-Fi connected

Red & Green, Alternately Flashing

Firmware is being updated

Red, Flashing Slowly

Network connection failed, network is disconnected

Red, Flashing Rapidly

Malfunctioning, boot failure, SD card malfunction

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.