FCC Compliance Statement

FCC Compliance Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

2. The user’s manual or instruction manual for an intentional or unintentional radiator shall caution

the user that changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment. In cases where the manual is provided

only in a form other than paper, such as on a computer disk or over the Internet, the information

required by this section may be included in the manual in that alternative form, provided the user

can reasonably be expected to have the capability to access information in that form.

3. (b) For a Class B digital device or peripheral, the instructions furnished the user shall include the

following or similar statement, placed in a prominent location in the text of the manual: NOTE: This

equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures: -- Reorient

or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. --

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected. -- Consult the dealer or an experienced radio/TV technician for help.

4. RF exposure warning This equipment must be installed and operated in accordance with provided

instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance

of at least 20 cm from all persons and must not be co-located or operating in conjunction with any

other antenna or transmitter. End-users and installers must be provided with antenna installation

instructions and transmitter operating conditions for satisfying RF exposure compliance.