Device Installation

The device can adopt two types of installation mode which are desktop installation and ceiling mount.

Please refer to Figure 4‑1 for desktop installation.

For desktop installation, you just need to stick the device on the installation surface.

Please refer to Figure 4‑2 for ceiling mount.

The exact installation steps are shown as follows:

Step 1: Dig holes on the proper installation surface according to the hole sites on the quick installation board.

Step 2: Knock the expansion bolts into the holes.

Step 3: Use self-tapping screws to fix the quick installation board well.

Step 4: Connect to device power.

Step 5: Adjust the monitoring angle and stick the device on the quick installation board.

Note:

• This quick start guide is for reference only. Slight difference may be found in user interface.
• All the designs and software here are subject to change without prior written notice.
• All trademarks and registered trademarks mentioned are the properties of their respective
  
• If there is any uncertainty or controversy, please refer to the final explanation of us.

Please visit our website or contact your local service engineer for more information